OMRON XW2R (PLCs) Connector-Terminal Block Conversion Units for PLCs

2024-08-08 16:07:00 admin

OMRON

XW2R (PLCs)

Connector-Terminal Block Conversion Units for PLCs

Specifications:

Models for Connection to OMRON PLCs

with power supply terminals

e-CON Type

Rated current		Power supply terminal block: 4 A/16 poles or 8 A/32 poles
		Connectors/e-CON Connectors: 1 A (However, rated current of e-CON Connector depends on the wires that are used.)
Rated voltage		24 VDC
Insuration resistance		100 MΩ min. (at 500 VDC)
Dielectric strength		500 VAC for 1 min (leakage current: 1 mA max.)
Ambient operating temperature		0 to 55°C
Applicable wires	Applicable wire sizes	AWG 24 to 14 (ferrules) AWG 28 to 14 (stranded wires) AWG 28 to 16 (solid wires) * (Outer diameter of insulation must be 4 mm max)
	Stripped length	AWG 28-16: 8 to 10 mm AWG 14: 9 to 10 mm

* This is the applicable range for the power supply terminal block. For the applicable wire sizes for I/O Connectors (e-
CON), refer to "Input Device Connectors: XN2 e-CON Connectors".

without power supply terminals

Phillips screw

Rated current		0.5 A/signal, 4 A/common
Rated voltage		24 VDC
Insuration resistance		100 MΩ min. (at 500 VDC)
Dielectric strength		500 VAC for 1 min (leakage current: 1 mA max.)
Ambient operating temperature		0 to 55°C
Applicable wires	Applicable wire sizes	AWG 22 to 16 (round or forked crimp terminals) AWG 26 to 16 (stranded or solid wires)
	Stripped length	9 mm
	Tightening	0.5 Nm

Slotted screw (rise up)

Rated current		0.5 A/signal, 4 A/common
Rated voltage		24 VDC
Insuration resistance		100 MΩ min. (at 500 VDC)
Dielectric strength		500 VAC for 1 min (leakage current: 1 mA max.)
Ambient operating temperature		0 to 55°C
Applicable wires	Applicable wire sizes	AWG 22 to 16 (ferrules) AWG 26 to 16 (stranded or solid wires)
	Stripped length	7 mm
	Tightening	0.5 to 0.6 Nm

OMRON ​XW2R (PLCs) Connector-Terminal Block Conversion Units for PLCs